Return To Cor-Ban® Webpage
White Cor-Ban Bucket With A Handle On Top, A Red Plane and Graphics, and the Zip-Chem Cloud Logo On ItPerson Using The Cor-Ban 35 Aerosol CanCor-Ban 35 Aerosol Can With A Formit Wand Attached To It


Cor-Ban® 35 is designed to be a long lasting, high solids, low volatiles, high penetration, and water displacing corrosion inhibiting compound for use on the following high profile aircraft substrates.

  • Upper Edge Floor Beams
  • Wheel Wells
  • Pressure Deck
  • Center Wing Sections.

The finished coating is non-tacky with a light, reddish-pink tint. Cor-Ban® 35 offers the fast dry time and thin film of BMS 3-23 as well as the long lasting corrosion inhibition properties of BMS 3-29.

Application of Product

Cor-Ban® 35 can be applied by conventional airless or air-operated spray equipment. The coating should be applied at 1 to 1½ mils (25-38 microns) wet thickness.

Aerosol application is available.

The Cor-Ban® 35 aerosol can be used in conjunction with the Formit® extensions to provide targeted spray to areas that may be difficult to reach but need to be coated. Please refer to our Formit® technical data sheet for more information.

All properties represented were achieved with a dry film thickness of 0.5-0.75 mils (12-19 microns).

One aerosol can covers approximately 95 ft² (8.8 m²) and 1 gallon of bulk material can cover approximately 1600 ft² (39.3 m² per liter).

Cured Cor-Ban® 35 can be removed with Sur-Prep® 3167, Sur-Prep® 3160, or Zip-Strip 125M.


  • Water Displacing
  • Non-Sagging Thixotropic Film
  • High Penetration
  • Fast Drying Non-Tacky Film
  • Low VOC
  • > 2000 hours salt spray
  • Detectable Film
  • Non-Cracking and Flaking to -40°F (-40°C)
  • Solvent Removable
  • High Solids: >51%
  • Very low dry film weight (< 1 mil required to surpass specification)


Cor-Ban® 35 conforms to the requirements of the following specifications:

Physical Properties

  • Flash Point: 115°F (46°)
  • Specific Gravity: 0.90
  • Water Displacement: 0% Rust
  • Non-Volatiles: 51% min.
  • Material VOC: 395 g/L
  • Drying Time: <1 hour
  • Color: Transparent reddish-pink
  • Exfoliation: Pass
  • Solvent Type: Aliphatic
  • Low Temp Flaking: Pass
  • Penetration: BMS 3-23G pass
  • Compatibility Cd, Mg, AI: Pass
  • Operating Temperature: -65°F (-54°C) to 350°F (177°C)


Aerosol (004675)

8 oz Brush In Cap (010884)

Quarts (009408)

Gallons (009409)

5 Gallon Pail (002104)

55 Gallon Drum (002105)

Special packaging upon request

Download technical data sheet of Cor-Ban® 35 by clicking on the TDS button below

Contact Zip-Chem® Products

Contact Zip-Chem® Products to request Cor-Ban® 35 packaging and the Cor-Ban® 35 SDS.

Submit An Image, Video, Or Document

Click here to submit an image, video, or document of a Cor-Ban® 35 inquiry or corrosion challenge that you are facing.

Return To Cor-Ban® Webpage