Return To Sur-Prep® Webpage


Description


The Sur-Prep® 3500-1 Non-Decorative Interior Structure Surface Prep Kit can be used to prepare the interior structure, fuel tank structure, and wing structure surfaces for painting and sealing.


Kit Contains


Each Sur-Prep® 3500-1 Non-Decorative Interior Structure Surface Prep Kit contains the following:


1) Alkaline Cleaning Solution Pad that is labeled as Step 1.


2) Deionized Water Wipe and Dry Towel that is labeled as Step 2.


3) Citra-Safe® Deodorized Wipe and Dry Towel that is labeled as Step 3. (Caution: Combustible! Avoid skin and eye contact. In case of skin contact, remove contaminated clothing and wash skin thoroughly with soap and water. If splashed into eyes, flush eyes with water for at least 15 minutes or until the irritation subsides. Wear nitrate gloves and safety glasses or goggles when handling this product. Consult SDS for additional information.)


4) Conversion Coating Material Wipe that is labeled as Step 4.


(Danger: Chromic acid mixture. Corrosive to skin and eyes. Avoid skin and eye contact. Avoid breathing mist from solution. Wear safety goggles or face shield and nitrate gloves when handling this product. In case of eye contact, flush eyes with water for at least 15 minutes, and then seek medical attention. Consult SDS for additional information.)


5) Deionized Water Wipe and Dry Towel that is labeled as Step 5.


Instructions


Instructions For Sur-Prep® 3500-1 Non Decorative Interior Structures Surface Prep Kit


Note: Both mating surfaces should be cleaned and conversion coated prior to painting or sealing.


  1. Remove any loose paint or sealant with a micarta scraper.
  2. Vacuum area to remove any loose debris, metal shavings, and dirt.
  3. Lightly abrade entire area of parts to be sealed or painted using Step 1 - Scotchbrite with alkaline cleaner. Be sure to remove the alcad identification marking.
  4. Wipe area with Step 2 - Deionized water towel to remove soap residue immediately followed with the dry wipe.
  5. Repeat with a second water wipe and dry the area.
  6. Solvent clean area with Step 3 -Deodorized Citra Safe® wipe. Do not allow the solvent to dry on the surface. Wipe it with the dry wipe.
  7. Apply conversion coating material by placing the unfolded Step 4 - conversion coating material 600 towel on the surface. Allow the towel to sit on the surface for 2-5 minutes. Do not allow the conversion coating material to dry on the surface.
  8. Neutralize the conversion coating material by wiping with Step 5 - Deionized water. Immediately follow with the dry wipe.
  9. Place all used towels in plastic bag. Remove all air from the bag and seal. Dispose of plastic bag as hazardous waste. (Caution: Do Not Allow Conversion Coating Material Towels To Dry. (Spontaneous Combustion May Occur). Be Sure To Remove Air, Seal The Bag, And Dispose Of Properly.)
  10. Apply paint or sealant within two hours, if required.

Packaging


Available in a 12 gram kit (104089) and a l oz kit (104090)


Download technical data sheet of Sur-Prep® 3500-1 by clicking on the TDS button below



Contact Zip-Chem® Products


Contact Zip-Chem® Products to inquire about or request Sur-Prep® 3500-1 including the Sur-Prep® 3500-1 SDS.


Return To Sur-Prep® Webpage