Applications
Intended for use on aircraft substrates such as:
- Upper edge floor beams
- Wheel wells
- Pressure deck
- Center wing sections
- Interior fuselage
- Flap tracks
- Landing gear wells
Apply Cor-Ban® 35 by using conventional airless or air-operated spray equipment or by using aerosol
Apply at 1 – 1½ mils (25-38 microns) wet thickness. This wet thickness can be measured with Zip-Chem® ’s Wet Film Thickness Gauge.
The Cor-Ban® 35 aerosol can be used in conjunction with the Formit® extensions to provide targeted spray to areas that may be difficult to reach but need to be coated. See our Formit® technical data sheet for more information.
All properties represented were achieved with a dry film thickness of 0.5-0.75 mils (12-19 microns).
One aerosol can covers approximately 95 ft2 (8.8 m2)
1 gallon of bulk material covers approximately 1600 ft2 (39.3 m2 per liter)
Remove Cured Cor-Ban® 35 with Sur-Prep® 3167, Sur-Prep® 3160, or Zip-Strip™ 125M.
English 
简体中文