Intended for use on high profile aircraft substrates:
- Upper edge floor beams
- Wheel wells
- Pressure deck
- Center wing sections
Apply by conventional airless or air-operated spray equipment.
The coating should be applied at 1 – 1½ mils (25-38 microns) wet thickness. This wet thickness can be measured with Zip-Chem® ’s Wet Film Thickness Gauge.
Aerosol application is available
The Cor-Ban® 35 Undyed aerosol can be used in conjunction with the Formit® extensions to provide targeted spray to areas that are difficult to reach but need to be coated. See our Formit® technical data sheet for more information.
All properties represented were achieved with a dry film thickness of 0.5 – 0.75 mils (12-19 microns).
One aerosol can covers approximately 95 ft2 (8.8 m2 ).
Cured Cor-Ban® 35 Undyed can be removed with Sur-Prep® 3160, D-5640NS, Zip-Strip™ 125M, Sur-Prep® 3167, or mineral spirits.